Long-Term Complications of Fistula - Vascular AccessArticle by a Renal Nurse
Labels: Vascular Access
Steal Syndrome
Is a set of symptoms caused by hypoxia (lack of oxygen to the tissues).
'Patients feel pain that can range from minor to severe.
In most patients, steal syndrome pain lessens over time because extra blood vessels grow and supply blood to the area (collateral circulation)
Some of the symptoms to watch for or ask your patients about include:
Pain in the access limb
Tingling in the access limb
Cold feeling in the access limb
A change in motor skills in the hand.
Nail beds that are blue in color
Necrotic (dead / slacked) spots on the ...
Decreased feeling in the access limb
Try to keep the patient's hand warm during dialysis, perhaps with a mitten, blanket, or tube sock.
Changing the position of the patient's arm may help increase blood flow in the hand
Can be treated by reducing blood flow through the fistula, making the vessels larger, or tying off some blood vessels surgically.
Aneurysm
Putting needles in the access in the same general area time after time can cause an aneurysm.
This pattern of cannulation weakens the vessel wall and causes a bulge or "gumdrop" to"ballooning" to form the access.
Aneurysms are more likely to occur upstream
(retrogradeO from a venous stenosis, especially at sites of repeat needle insertion.
The sites are easy to see.
Rotate needle puncture sites or use the buttonhole technique to prevent aneurysms.
Do not insert needles into areas of aneurysms.
Aneurysms leave less surface area for cannulation.
Stenosis
Is a narrowing of the blood vessel that shows the flow of blood through the access.
There are three major sites where stenosis is likely to form:
1. Inflow
The most common type of inflow stenosis is called juxta-anastomotic stenosis (JAS).
It is found in the vein right next to the anastomosis.
It will keep a fistula from maturing because it does not allow enough blood flow to enter the fistula.
It may be due to stretching, twisting, or other trauma during the fistula surgery.
2. Outflow
Can occur anywhere along the outflow vein.
May occur in an area where the patient has had an IV placed in the past.
The area past the stenosis may appear smaller, making needle insertion more difficult for fear of infiltration.
3. Central vein
Central venous stenosis occurs in the large draining vein of the arm, often in the shoulder area.
If a stenosis is suspected, the venous system should be checked from the fistula to the heart, so a central stenosis can be found.
These stenosis are most likely caused by catheter placement in the past.
Stenosis Symptoms:
High-pitched or louder-pitched bruit
Harsh or water-hammer pulse
Discontinuous bruit (each sound separate - whoosh . whoosh... whoosh) Decreased thrill
Trouble inserting or threading the dialysis needles.
Swelling of the patient's access limb Increased venous pressure during treatment,
Forcing you to turn the blood pump down
Recirculation
Extracorporeal system clotting off during treatment Increased bleeding after needles are removed postdialysis
"Black blood syndrome"
Decrease kt/v and URR
Inability to obtain prescribed blood flow rate
Is caused by injury of the blood vessel lining that scars the blood vessel and creates flow turbulence.
This leads to overgrowth of smooth muscle cells or aneurysm formation.
Stenosis may recur after treatment.
To find venous or arterial stenosis, dye is injected into the vessel. With the dye, any narrowing will show up on an x-ray (fistulogram, venogram)
It can also be found by color Doppler ultrasound.
Ultrasound is a non-invasive way to look at blood vessels and blood flow.
Some cases can be treated with angioplasty, which is an outpatient procedure.
The doctor threads a catheter with an inflatable balloon tip into the vessel
Once the balloon is in place, he/she inflates it to expand the vessel lumen
Thrombosis
Formation of a thrombus, or blood clot
Occurs in all types of a vascular access, but less than 1/6 as often in AVFs than in grafts
Blood has a number of components ..o stop a wound from bleeding by forming a clot.
These include clotting proteins called plasma coagulants and platelets - tiny blood cells that sticr. together to seal off damaged blood vessels.
Platelets clump when they are "activated" by contact with damaged blood vessel walls or by turbulence inside a blood vessel.
Activated platelets and damaged tissues signal blood clotting proteins to form a strong net of fibers (fibrin).
This net traps more platelets and RBCs, so the clot gets more solid as it grows bigger
A clot may start to form any time there is low blood flow due to low blood pressure, dehydration, or too much pressure on access,
These conditions let blood pool at a damaged surface, like a needle site.
In a fistula, blood flow through an area of stenosis may cause enough turbulence to activate platelets, so they stick to the vessel wall.
Repeated cannulalions also damage vessel walls, causing rough surfaces that activate platelets.
Early thrombosis is most often caused by surgical problems with the anastomosis or twisting of the blood vessel.
It can also be caused by stenosis, reduced blood flow due lo hypotension at dialysis, a cardiac arrest, or compression of the vessel.
The vessel can be compressed after surgery if blood leaks into the tissues causing swelling and
hematoma.
Hematomas may also form at the site of an infiltration, or if an access is used too soon after surgery.
Applying too much pressure for too long to the puncture site after treatment may also lead to thrombosis.
Pressure should not be placed on a puncture site for more than 20 minutes.
If bleeding lasts longer than 20 minutes, the nurse should look at the heparin dose and check for an access problem, like stenosis.
Late thrombosis may develop in a fistula that was working. It can be caused by increased turbulence from stenosis.
Untreated thrombosis can destroy an access
Thrombosis is most often caused by stenosis and low blood flow.
Signs of pending access thrombosis:
Reduced thrill and bruit
Poor blood flow through the access
Inability to obtain prescribed blood flow rate
Sudden swelling of the hand on the access arm in a patient with a history of stenosis and blood flow problems
Abnormally high venous pressure readings during dialysis
A high recirculation rate; always check if the needle placement may have had an effect before calling the nephrologist Increased TMP.
Suspect thrombosis if you feel no pulse or thrill and hear no bruit along the outflow vein.
Thrombosis in a previously working access often follows stenosis. Early detection and repair of stenosis may help save the access.
The KDQI Clinical Practice Guidelines for Vascular Access recommend that centers have an access monitoring program. - it helps to improve patient's vascular access outcomes by identifying problems early.
AVF can be monitored through measurement of dynamic and static venous pressure, access flow measurement, and duplex ultrasound.
Thrombosis can be treated b surgical, mechanical, or . chemical (use of drug to dissolve the clot) thrombectomy.
90% of cases ~ stenosis is the cause of the clot
This maybe corrected by surgery to revise the access, or angioplasty after the clot is removed.
Patient Actions to Prevent Thrombosis
To avoid thrombosis, patient should:
Prevent medical staff from using the access or access limb for routine blood draws, IVs, or blood pressure checks
Feel for the thrill and listen to the bruit daily to ensure patency
Think about learning how to self-cannulale to reduce the risk of mispuncture
Patient should not:.
Sleep on the access arm
Put too much treasured on the puncture site after removing the dialysis needle
Wear tight-fifing clothing or jewelry that squeeze the access arm
Carry object objects across the arms that compress the access, such as a purse
Use the access for IV drugs
Wear a watch on the hand that has a radiocephalic or lower arm fistula
High Output Cardiac Failure
An AVF can be one cause of high output cardiac failure.
This is a complex condition in which:
The fistula brings more blood to the heart
The heart works harder, reducing resistance in the arteries
Arterial blood pressure falls
The drop in arterial blood pressure triggers the renin-angiotensin system
Patients with high output cardiac failure may have rapid pulses as their hearts try to make up for the extra blood flow (20% or greater) caused by the access.
They may be short of breath if the blood does not contain enough oxygen.
Swelling may occur In the hands and fee because return circulation to the hearts poor.
If untreated, it can cause chest pain, fluid in the lungs, abnormal heart rhythms, and death.
High cardiac output may also be caused by anemia or heart disease the patient had before the vaacular access
Prevention is best aimed at treating anemia and creating an access that will not tax the patient's hcart.
If high output cardiac failure occurs, limiting fluid gain between treatments will reduce the strain on the heart.
Longer and/or more frequent treatments may help will fluid gains, reducing the strain.
Medication may also be given to help the heart beat strongly.
Surgery may be needed to reduce blood flow through the access.
Surgery is either done either to band the arterial anastomosis or to tie off the fistula.
http://dialysis-patient-care.blogspot.com/2010/11/long-term-complications-of-fistula.html