I Hate Dialysis Message Board

Dialysis Discussion => Dialysis: Home Dialysis - NxStage Users => Topic started by: Roadrunner on August 09, 2008, 11:53:56 AM

Title: Pure Flow setting doesn't match Sak
Post by: Roadrunner on August 09, 2008, 11:53:56 AM

Hi,
If the pureflow setting doesn't match the sak, what happens.   ???
Example:  Pure Flow is set for Sak-01 and you use SAK-02 or visa versa.

Title: Re: Pure Flow setting doesn't match Sak
Post by: jbeany on August 09, 2008, 01:47:36 PM

It won't let you pass the testing phase, and you have to drain the whole batch and start over, making sure to reset the Sak number to match.

(Been there - done that!)

Title: Re: Pure Flow setting doesn't match Sak
Post by: Roadrunner on August 09, 2008, 02:42:48 PM

Quote from: jbeany on August 09, 2008, 01:47:36 PM

It won't let you pass the testing phase, and you have to drain the whole batch and start over, making sure to reset the Sak number to match.

(Been there - done that!)

It will.  I have been running it this was for 4 weeks.

Title: Re: Pure Flow setting doesn't match Sak
Post by: jbeany on August 09, 2008, 06:09:51 PM

Mine wouldn't pass the conductivity test when I did by accident after I had to change out the control unit.