I Hate Dialysis Message Board

Dialysis Discussion => Dialysis: Home Dialysis - NxStage Users => Topic started by: slipkid on March 29, 2014, 11:06:31 AM

Title: How do I change the flow fraction on the machine.
Post by: slipkid on March 29, 2014, 11:06:31 AM

The subject line says it all.

Title: Re: How do I change the flow fraction on the machine.
Post by: Speedy1wrc on March 30, 2014, 08:20:08 AM

I'm on the machine now so I can't reach the book to give you the setting number.

You need to go into settings and change the value for the setting number.

Get your cycler book and go to the tab titled settings. It'll walk you through getting to settings. Then look at the setting number list to find the one for ff.

Title: Re: How do I change the flow fraction on the machine.
Post by: slipkid on March 30, 2014, 02:50:42 PM

Speedy:

I found the relevant section in the Users Guide.  I believe I can take it from here.

Thanks for your help.

Title: Re: How do I change the flow fraction on the machine.
Post by: Speedy1wrc on March 30, 2014, 07:14:56 PM

How did you make out?

Title: Re: How do I change the flow fraction on the machine.
Post by: slipkid on March 31, 2014, 11:51:02 PM

Speedy:

My experiment was successful.  Again, thanks for your reply to my question.

Title: Re: How do I change the flow fraction on the machine.
Post by: Speedy1wrc on April 01, 2014, 07:25:43 PM

Excellent